| Description: |
| Enables students to investigate nature and properties of electricity by using simple circuits which are easily constructed on a base board. The connector system uses p.c.b. strips with cut-out sections whose ends can easily be inserted in spring terminals, ensuring low contact resistance and ease of connectlon. The kit consists of :
1Baseboard, plastic. with spring terminals and three battery holders.
3Batteries
10Lamps 1.25 V m.e.s.
6Lamp holders mounted on p.c.b.connectors
10Plain connector p.c.bs.
1Wire wound potentiometer with crocodile clip connections
1Silicon diode
1Resistor 3.9 ohm 2.5 W
1 pair Leads, red, with crocodile clip at each end
1 pair Leads, black, with crocodile clip at each end
1 pair Leads, yellow, with crocodile clips at each end
2Switches mounted on p.c.b. connectors
2Soft iron nails, 5 cm long
2mBare copper wire, swg 20
2mBare eureka wire, swg 34
2mPlastic covered copper wire
1Electrode support
10Pencil lead electrodes
1Sheet copper foil, 150 mm square
1Pack Steel wool
1Instruction manual in English. |
|
